I plugged this heater in my garage in the wintertime and put my cat's water dish.
On it. She's feral and and I'm able to lift my garage door from my phone when I see her sitting on my porch with my blink camera. And?
And it keeps our water from freezing in the wintertime.
So she's always able to. Get a drink.
Enjoy fast, free delivery, exclusive deals, and award-winning movies & TV shows with Prime
Try Prime
and start saving today with fast, free delivery
Add a debit or credit card to save time when you check out
Convenient and secure with 2 clicks. Add your card
Make it a bundle
We found 2 bundles with this item:
BN-LINK Reptile Heating Pad Electric Indoor Under Tank Terrarium Heating Mat Waterproof for Turtles, Lizards, Frogs, and Other Reptiles, 8" X 12"
Page 1 of 1Start overPage 1 of 1
-
BN-LINK Reptile Heating Pad 8" X 12" for Turtles, Lizards, Frogs, and Other Reptiles, Bluetooth Hygrometer Thermometer with App Control$26.99 $28.58This bundle contains 2 items -
BN-LINK Reptile Heating Pad 8" X 12" with Thermostat Controller$32.99 $34.98This bundle contains 2 items
Frequently bought together
Top rated similar items
Page 1 of 1 Start overPage 1 of 1
From the brand
-
About BN-LINK: A direct distributor of premium quality home improvement products. We strive to provide better products and after-sales service to help every customer's life easier and more convenient.
Our Products: remote control outlets, indoor & outdoor timers, smart plugs, heating & cooling thermostat controllers.
-
-
-
-
-
Product Description
Uniform Heating & Water-Resistant Design
5 Layer Protection Structure
Heat mat reaches desired temperature within minutes. This heating mat has a waterproof and moisture resistant design that allows it to endure any kind of wet conditions (Note: Please do not use it in water).
Fast heating & Save Energy Efficient
With fast heating and the uniform heat distribution, you’ll be able to heat up the area quickly and consistently. It is designed for reptile, amphibian, leopard gecko, snake, bearded dragon, lizard, turtle, Gekkonidae, hermit crab, and other small animal terrariums, as well as plant terrariums.
-
Various Uses Scenarios
An ideal environment for reptiles, amphibians, leopard gecko, turtle, hermit crab, small animals.
-
Save Energy Efficient
Rated 120VAC, 60Hz, 16W , Size: 8*12 inch
-
Easy to Clean
Just wipe down the mat to easily maintain the cleanliness of the heating mat !
-
Keep Your Reptiles Warm
Idea 24-Hour heat source for reptiles.
1 Example: Bearded Dragon 2 Example: Tortoise 3 Example: Snake 4 Example: Lizard
Reptile Heat Pad Single
Many Options by BN-LINK
8*12inch | Size | 8*12inch |
Simple Use | Function | Adjustable Knob |
120VAC, 60Hz, 16W | Rating | 120VAC, 60Hz, 16W |
30 -40 gallon | Tank Volume | 30 -40 gallon |
8*12inch | Size | 8*12inch |
Simple Use | Function | Digital Thermostat |
120VAC, 60Hz, 16W | Rating | 120VAC, 60Hz, 16W |
30 -40 gallon | Tank Volume | 30 -40 gallon |
8*12inch | Size | 6*8inch |
Simple Use | Function | Simple Use |
120VAC, 60Hz, 16W | Rating | 120VAC, 60Hz, 8W |
30 -40 gallon | Tank Volume | 10 -20 gallon |
8*12inch | Size | 6*8inch |
Simple Use | Function | Adjustable Knob |
120VAC, 60Hz, 16W | Rating | 120VAC, 60Hz, 8W |
30 -40 gallon | Tank Volume | 10 -20 gallon |
Videos
Page 1 of 1Start OverPage 1 of 1
Videos for this product
1:36
Click to play video
Before you buy this Reptile Heating Pad, watch this!
Ecomvandemic
Videos for this product
1:11
Click to play video
Quick thoughts, demo, setup of heating mat for reptiles
Marie Juice
Videos for this product
0:54
Click to play video
My favorite thing about this Reptile Terrarium Heating Mat
Ecomvandemic
Videos for this product
0:20
Click to play video
BN-LINK Seedling Heat Mat and Temperature Controller Set
BN-LINK
Reviews with images
CHINA ACTUALLY PRODUCED SOMETHING THAT WORKS!
I thought I was buying a heating pad, basically what you're buying is a controller that comes with a free heating pad. I can't believe the price of this, I would expect at least $50. Especially considering that it is for pet use.It is a temperature controller, displays current temp inside tank, and has a separate permanently wired temp sensor that sticks to the inside of the tank with a suction cup. The suction cup works very well, even after repeated removals. The heating pad plugs in separately to a 110v plug on the controller. You can use any 110v device, I would only recommend using a heater or heat lamp though lol. I suppose you could wire it into a stereo, and when the temperature gets above your set point it starts playing Jimi Hendrix. The problem with that, is you then have to figure out whether or not your reptile is more of a country fan, or a rock fan..The heating pad is completely covered with adhesive on one side for sticking to OUTSIDE of the tank.It's a lot larger than I expected, although I didn't look too see what size I was buying - I just expected smaller.The instructions say multiple times to place on the outside of the tank, so be aware of that. Also, it is absolutely not supposed to be placed on wood or anything other than glass, according to the instructions, so be aware of that.After reading the instructions, and being aware of that, I decided to just set it under the tank, on top of wood. It wasn't even real wood. It was crap particle board. Maybe the glue in the particle board increased its thermal properties, but I doubt it. I think it's more probable that the heating pad doesn't get hot enough to catch wood on fire.I didn't stick it to the tank because we are replacing the tank in a month. I then decided to move the tank and stick it to the side of the tank temporarily, so I removed a half inch or so (ended up being about an inch) of the adhesive backing all the way around the edge of the heating pad and stuck it to the glass so that I can remove it, and the rest of the adhesive is unused for the new tank.If this is not an absolute permanent fixture on your tank, I would advise sticking it to the tank using only a little bit of the adhesive (by removing small sections of at the adhesive backing to expose only small areas of adhesive). You will never get this off the tank in reusable condition if you use the entire adhesive sheet. I probably exposed too much adhesive. It's going to be a pain when I go to remove it.
Top reviews from the United States
There was a problem filtering reviews right now. Please try again later.
Reviewed in the United States on February 2, 2023
It is a temperature controller, displays current temp inside tank, and has a separate permanently wired temp sensor that sticks to the inside of the tank with a suction cup. The suction cup works very well, even after repeated removals. The heating pad plugs in separately to a 110v plug on the controller. You can use any 110v device, I would only recommend using a heater or heat lamp though lol. I suppose you could wire it into a stereo, and when the temperature gets above your set point it starts playing Jimi Hendrix. The problem with that, is you then have to figure out whether or not your reptile is more of a country fan, or a rock fan..
The heating pad is completely covered with adhesive on one side for sticking to OUTSIDE of the tank.
It's a lot larger than I expected, although I didn't look too see what size I was buying - I just expected smaller.
The instructions say multiple times to place on the outside of the tank, so be aware of that. Also, it is absolutely not supposed to be placed on wood or anything other than glass, according to the instructions, so be aware of that.
After reading the instructions, and being aware of that, I decided to just set it under the tank, on top of wood. It wasn't even real wood. It was crap particle board. Maybe the glue in the particle board increased its thermal properties, but I doubt it. I think it's more probable that the heating pad doesn't get hot enough to catch wood on fire.
I didn't stick it to the tank because we are replacing the tank in a month. I then decided to move the tank and stick it to the side of the tank temporarily, so I removed a half inch or so (ended up being about an inch) of the adhesive backing all the way around the edge of the heating pad and stuck it to the glass so that I can remove it, and the rest of the adhesive is unused for the new tank.
If this is not an absolute permanent fixture on your tank, I would advise sticking it to the tank using only a little bit of the adhesive (by removing small sections of at the adhesive backing to expose only small areas of adhesive). You will never get this off the tank in reusable condition if you use the entire adhesive sheet. I probably exposed too much adhesive. It's going to be a pain when I go to remove it.
Size: 8" X 12" with ThermostatVerified Purchase
CHINA ACTUALLY PRODUCED SOMETHING THAT WORKS!
Reviewed in the United States on February 2, 2023
I thought I was buying a heating pad, basically what you're buying is a controller that comes with a free heating pad. I can't believe the price of this, I would expect at least $50. Especially considering that it is for pet use.Reviewed in the United States on February 2, 2023
It is a temperature controller, displays current temp inside tank, and has a separate permanently wired temp sensor that sticks to the inside of the tank with a suction cup. The suction cup works very well, even after repeated removals. The heating pad plugs in separately to a 110v plug on the controller. You can use any 110v device, I would only recommend using a heater or heat lamp though lol. I suppose you could wire it into a stereo, and when the temperature gets above your set point it starts playing Jimi Hendrix. The problem with that, is you then have to figure out whether or not your reptile is more of a country fan, or a rock fan..
The heating pad is completely covered with adhesive on one side for sticking to OUTSIDE of the tank.
It's a lot larger than I expected, although I didn't look too see what size I was buying - I just expected smaller.
The instructions say multiple times to place on the outside of the tank, so be aware of that. Also, it is absolutely not supposed to be placed on wood or anything other than glass, according to the instructions, so be aware of that.
After reading the instructions, and being aware of that, I decided to just set it under the tank, on top of wood. It wasn't even real wood. It was crap particle board. Maybe the glue in the particle board increased its thermal properties, but I doubt it. I think it's more probable that the heating pad doesn't get hot enough to catch wood on fire.
I didn't stick it to the tank because we are replacing the tank in a month. I then decided to move the tank and stick it to the side of the tank temporarily, so I removed a half inch or so (ended up being about an inch) of the adhesive backing all the way around the edge of the heating pad and stuck it to the glass so that I can remove it, and the rest of the adhesive is unused for the new tank.
If this is not an absolute permanent fixture on your tank, I would advise sticking it to the tank using only a little bit of the adhesive (by removing small sections of at the adhesive backing to expose only small areas of adhesive). You will never get this off the tank in reusable condition if you use the entire adhesive sheet. I probably exposed too much adhesive. It's going to be a pain when I go to remove it.
Images in this review
Top reviews from other countries
Josie A.
Temperature controlled
Reviewed in Canada on April 30, 2024Size: 8" X 12" with ThermostatVerified Purchase
Marco ALEJANDRO
Excelente regulador
Reviewed in Mexico on August 11, 2022Size: 8" X 12" with ThermostatVerified Purchase
Pedro Ivan Sosa Torres
Baja potencia
Reviewed in Mexico on December 10, 2021Size: 6" X 8" with ThermostatVerified Purchase
Brent R T Poole
Works great!
Reviewed in Canada on March 22, 2024Size: 8" X 12" with ThermostatVerified Purchase
Cliente de Amazon
fácil de instalar
Reviewed in Mexico on June 14, 2022Size: 8" X 12" with ThermostatVerified Purchase
